How to Reset Hayward Aqua Rite Salt Chlorine Generator? Quick Power Tools

Reset Hayward Aqua Rite. OEM Hayward Goldline Aqua Rite Main Board GLXPCBRITE Occasionally the salt level on the Hayward Aqua Rite may not match the actual salt level of the pool This indicates a possible circuit board fault or electrical issue

To reset the Inspect Cell LED, press and hold the diagnostic button for 3 to 5 seconds, and the LED light should go out. Call the Hayward service department at (908) 355-7995 for assistance.

How To Reset Hayward Salt Generator

To reduce the risk of electrocution and or electric shock hazards: Only qualified technicians should remove the panel Replace damaged wiring immediately Insure panel is properly grounded and bonded HAYWARD This indicates a possible circuit board fault or electrical issue If the salt cell is clean but the salt reading is off, the Aqua Rite will need to be recalibrated.

Hayward Introduces Advanced AquaRite S3 Salt Sanitization System. If the salt cell is clean but the salt reading is off, the Aqua Rite will need to be recalibrated. To reduce the risk of electrocution and or electric shock hazards: Only qualified technicians should remove the panel Replace damaged wiring immediately Insure panel is properly grounded and bonded HAYWARD

How To Use Hayward Aqua Rite Salt Chlorine Generator YouTube. Release the button and your Aqua Rite will be reset Aqua Rite/Aqua Rite XL Diagnostics High Voltage Electrocution Hazard Hazardous voltage can shock, burn, cause serious injury and or death